توضیحات محصول
I.C.C manufactures a wide range of polyether polyols that allow formulators to produce high quality polyurethanes. Polyols contain reactive hydroxyl (OH) groups which react with isocyanate (NCO) groups on isocyanates to form polyurethanes. Polyol RI4400 is a glycerin/sucrose-initiated polyether polyol. The high functionality of the initiators yields a resultant polyol with a nominal functionality of 4.2. Due to this polyol’s high functional nature, it is typically used in rigid foam and its applications. Blending this polyol with other polyether polyols allows for foam systems with high to low degrees of crosslinking. In addition, Polyol RI4400 is a neutral material, which presents the formulator with complete catalytic control over a system. We offer a wide variety of raw materials for the production of molded rigid foams.
Polyol RI4400 is a clear, light colored and low viscosity polyol. Polyol RI4400 has excellent compatibility with blowing agents and isocyanates for high index and isocyanurate foams, as well as appliance, high density and general-purpose foam formulations. Also, it is 100% active without any amine catalyst and relatively nontoxic.
| TEST | STANDARD TEST METHOD | RESULTS |
| Appearance | — | Liquid |
| Color at 50°C, APHA | ASTM D-1209 | Max. 50 |
| Density at 25°C, g/ml | ASTM D-1298 | 1.01±0.02 |
| pH (5% aqueous) | ASTM D-1172 | 6-8 |
| Viscosity at 25°C, cP | ASTM D-445 | 3900±100 |
| Hydroxyl value, mg KOH/g | ASTM D-4252 | 440±5 |
| Water, percent | ASTM E-203 | Max. 0.5 |
| Functionality | Calculated | 4.2 |
Inhalation: Remove victim from exposure to fresh air immediately, if not breathing, give artificial respiration; if breathing is difficult, give medical oxygen. Get medical aid immediately.
Ingestion: Rinse mouth with plenty of milk or water (only if victim is conscious and alert). Get medical aid immediately.
Skin Contact: If skin contact occurs, wash the affected area with plenty of water and a neutral soap for a minimum of 5 minutes.
Eye Contact: If eye contact occurs, wash with plenty of clean water or amphoteric eye solution for a minimum of 15 minutes, holding the eyes open, medical advice should be followed.
Polyol RI4400 is dispatched in polyethylene or corrugated steel, galvanized or carbon steel drums.
Polyol RI4400 is stable for 2 years when stored in the original sealed containers in a cool and dry place.
Appropriate literature has been assembled which provides information concerning the health and safety precautions that must be observed when handling Polyol RI4400. Before working with these products, you must read and become familiar with the available information on their hazards, proper use, and handling.
Possibility to obtain rigid foams with very good density and Compatibility with reactive polymeric polyols allows extension of application options.
Insulation
Rigid Board stock Foam
Molded Rigid Foam
Rigid Spray Coatings
No comment